LCD Display Module Adapter PCB for arduino Nokia 5110

Original price was: $10.00.Current price is: $9.00.

Features: 84 X 84 dot matrix LCD,can show 4 lines of characters Use serial interface communicate with the master processor,the number of interface signal line...

SKU: BS64065024 Category: tool Availability: In stock

Features:

  • 84 X 84 dot matrix LCD,can show 4 lines of characters
  • Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.
  • LCD controller/driver chip has been bound to LCD chip,the volume of LCD is small
  • Low power supply,the working current in normal situation is lower than 200A,and has power-down mode

Specification

Note:

  • LIGHT linked with GND, the backlight to be lit.
  • Use a 3.3V controller, otherwise the display can damage

LCD5110 Module:

  • RST reset
  • CEchip selection
  • DCdata/commands choice
  • DINserial data line
  • CLKserial Clock Spee
  • 3.3VVCC.
  • LIGHT back light control terminal.
  • GNDpower negative.
Add a Review

Your email address will not be published. Required fields are marked *

Related Products